Seiko I Infotech Inc SII IP-7700 Guia De Inicio Rapido página 42

(3) Push the scroller fl ange until it stops and turn the
handle clockwise until the fl ange is fi xed to the paper
tube.
Scroller fl ange
(4) Remove the fl ange spacers.
Flange spacer
3
Install the media roll fi tted with the scroller
fl anges into the printer roller groove properly.
Scroller fl ange
Flange support
4
Install the fl ange holders.
Cap side
Note
- Note that the shape of the right fl ange is diff erent from the
left one.
5
Handle
6
7
8
Printer rear (supply side)
Wiper side
Remove the protection bar and open the front
cover.
Protection bar
Move the media edge guards to each side so
that they are not under the media.
Media edge guards
Rotate the pressure control knob clockwise to
raise the pressure roller.
Takeup side
or
Pressure control knobs
Insert the media end into the paper feeder
while smoothing out the media by hand to
prevent wrinkles.
Paper feeder
If it is hard to insert the media end into the paper
feeder due to a curl of the media, interpose an interleaf
and insert the media end under the interleaf as shown
in the fi gure.
- Up curl - Down curl
Front cover
Supply side
Printer rear
41