Troubleshooting; Scrapping - KENT Razor SV17 Instrucciones De Uso

ENGLISH

TROUBLESHOOTING

Trouble
The motors do not turn on; no warning light turns
on
The warning lights (62, 63, 64) lash
simultaneously
The vacuum system motor does not turn on
The dirty water vacuuming is insuficient
The solution low is insuficient
The squeegee leaves marks on the loor
For further information refer to the Service Manual, available at any KENT Service Center.

SCRAPPING

Have the machine scrapped by a qualiied scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Battery
– Brushes
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest KENT Center especially when scrapping electrical and electronic components.
22
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR USE
The battery terminals (50) are disconnected
The batteries (50) are discharged
The brush motor is overloaded
There are foreign materials (tangled threads,
etc.) preventing the brush from rotating
The fuse is blown
The recovery water tank (31) is full
The vacuum grid (46) is clogged or the loat
is closing
The vacuum hose (22) is disconnected from
the squeegee (11) or it is damaged
The squeegee (11) is dirty, or the squeegee
blades (13, 14) are worn or damaged
The recovery water tank cover (6) is not
properly closed, or the gasket (42) is
damaged
The recovery water tank (31) is dirty (clogged
drain hole)
The solution ilter (20) is dirty
There is debris under the squeegee blades
(13, 14)
The squeegee blades (13, 14) are worn,
chipped or torn
909 6309 000(3)2009-11
Possible Cause
Connect
Charge
Use a different kind of brush
Clean the brush hub
Replace
Empty
Clean the grid and check the loat
Connect
Clean the squeegee or replace the blades
Check and/or clean the seating surface or
replace the gasket
Clean
Clean
Remove the debris
Replace the blades
Razor SV17
Remedy