Troubleshooting; Scrapping - KENT Edge 28B Instrucciones De Uso

ENGLISH

TROUBLESHOOTING

Trouble
The machine does not start when turning the
main switch to "I" or to "II".
The side broom does not operate.
The machine operates only when stationary,
otherwise it turns off and the red warning
light fl ashes.
The battery autonomy is low.
The batteries do not charge: the red warning
light (4) does not turn on when the plug is
inserted in the electrical mains socket.
For further information, refer to the Service Manual, available at any Kent Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to
the Law in force:
– Battery
– Brooms
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Kent Center especially when scrapping electrical and electronic components.
18
INSTRUCTIONS FOR USE
Possible cause
There is an open in a breaker (21).
The battery charger cable is connected to
the electrical mains.
The batteries are discharged.
There is an open in a breaker (20).
The batteries are discharged.
The batteries are dead.
There is no power supply at the electrical
mains socket.
146 3082 000(2)2007-06
Remedy
Reset the breaker by pressing the relevant
button.
Disconnect it and place it in the housing.
Charge the batteries.
Reset the breaker by pressing the relevant
button.
Charge the batteries. If the trouble persists,
have the batteries replaced at Kent Service
Center.
Have the batteries replaced at Kent Service
Center.
Check the electrical mains socket by trying
to connect another domestic appliance.
Edge 28B