Section Vl. Buttonhole Buttonhole; To Adjust Buttonhole Stitch Density; Starting To Sew - Sears Kenmore 385.15202 Manual De Instrucciones

SECTION Vl. BUTTONHOLE
Buttonhole
(_ Pattern selector:
0 Presser foot:
(_ Thread tension:
(_ Stitch length:
Sliding buttonhole foot
1 to5
(0°25 to 1)
, To adjust buttonhole stitch density
Set the stitch length dial between 0°25 and 1.0 to adjust
the buttonhole stitch density.
NOTE:Always check a buttonhole on a scrap of fabric to
make sure the adjustment satisfies you.
I
BH
®
®
®
• Starting to sew
Snap the buttonhole foot (J) on the presser foot holder.
Carefully mark the buttonhole length on the fabric_
Place the fabric under the foot, with the buttonhole marking
running toward you°
Move the slider (A) toward you, so that the red arrow (C) on
the slider aligns with the start mark (B)_ Lower the presser
foot
NOTE:The markings on the slider are engraved in
centimeters.
r
gq
Set the stitch selector at _ ..Sew forward until you reach the
front mark of your buttonhole. Stop sewing at a left stitch. ""
............................ J
!
C
A/
B
,,J
J
54