Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SECTION
VII. BUTTONHOLE
Bu_onhole
(_) Stitch selector:
(_) Stitch length:
(_) Needle thread tension:
(_
Presser foot:
Blue zone
1 to5
Sliding buttonhole foot
0
PATTERN
LENGTH
®
%
®
Depending on your preference, you may adjust stitch density
within the blue zone on the stitch length control.
* For more density, turn the stitch length control
toward"
0 ",
0
Fine stitches for lightweight fabrics.
* For less density, turn the stitch length control
toward"
1 "
(_) Coarse stitches for heavyweight fabrics.
NOTE: Always check a buttonhole on a scrap of
fabric to make sure the adjustment satisfies you.
• Starting
to sew
Carefully mark buttonhole length on fabric,
Place the fab_:ic under the foot with the buttonhole
marking running toward you
Move the slider (A) toward you so that the top mark
(C) on the slider meets the start mark (B) Line up
the markings on the foot with the top mark on the
fabric. Lower the presser foot.
NOTE: The markings on the slider are engraved in
centimeters
Iq
Set the stitch selector at _J . Sew forward until you
reach the front marking of your buttonhole. Stop
sewing at a left stitch_
f
(b
®
LENGTH_
58
Tabla de contenido
