After Each Use - Remington HC331 Manual Del Usuario

ENGLISH
STEP 1 – Nape of the neck – DIAGRAM A
Use setting 1 (6mm).
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a little
at a time.
STEP 2 – Back of the head – DIAGRAM B
With setting 3 (12mm), cut the hair at the back of the head.
STEP 3 – Side of the head – DIAGRAM C
With setting 1 (6mm), trim sideburns. Then change to setting 2 (9mm) and continue to
cut to the top of the head.
STEP 4 – Top of the head – DIAGRAM D
With setting 4 (15mm), cut hair on top of the head against the direction in which the hair
normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a small
hand comb. Cut over the hand comb with the hair lifted or hold the hair between the fingers
to lift it and cut it to the desired length.
Always work from the back of the head.
STEP 5 – The finishing touches – DIAGRAM E , F & G
Use the clipper without an attachment comb for close trimming around the base and sides of
the neck.
To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed
clipper at right angles to the head, tips of the blades lightly touching the skin and then work
downwards.
Your clipper is fitted with high quality blades. To ensure long lasting performance
of your clipper, clean the blades and unit regularly.

AFTER EACH USE

Ensure the clipper is switched off and disconnected from the mains.
Turn the clipper to the backside.
Press both buttons located above the switch the same time to open the hair pocket.
(DIAGRAM H).
Brush the accumulated hair from the blades and the hair pocket. Do not submerge the clipper
in water.
After cleaning close the hair pocket.
Place one or two drops of oil on the blades. Turn the clipper on to distribute the oil evenly,
wipe off any excess oil. Excess oil will cause damage to your product.
To clean the unit, wipe with a damp cloth and dry immediately.
080714_REM_IFU_HC330_22L.indd GB_3 080714_REM_IFU_HC330_22L.indd GB_3
All manuals and user guides at all-guides.com
CARE FOR YOUR HAIRCLIPPER
3
05.11.2008 11:48:18 Uhr 05.11.2008 11:48:18 Uhr