Changing The Blade; Cleaning, Care & Maintenance; Troubleshooting - Buffalo FS440 Manual De Instrucciones

UK

Changing the blade

• Warning: Before removing blade,
ensure to turn off blender, disconnect
from power supply and let it come to a
complete stop.
• Blade is sharp - handle carefully.
• A triangle blade is pre-mounted on the shaft.
• A round emulsifying blade is also supplied,
ideal for use with nursery/special diets to
prepare purée of vegetables, porridge, raw
carrot purée, fruit creams, etc. To use it:
1. Remove the shaft from the power pack.
2. Using the triangle blade removal kit, with
the round end holding the shaft top while
the triangle end covering the blade then
unscrewing, remove the triangle blade from
the shaft.
Blade removal kit
3. Mount the emulsifying blade securely using the
emulsifying blade removal kit.

Troubleshooting

Fault
The unit is not The unit is not switched on
working
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Unit stops working Overheating protection is
suddenly activated
Loud noise Blade not correctly fitted
6
FS440-FS441-FS442_ML_A5_v1_20211118.indb 6 FS440-FS441-FS442_ML_A5_v1_20211118.indb 6
Cleaning, Care &
Maintenance
•
•
•
•
Cleaning the shaft, blade guard, and
blade
•
•
•
•
Probable Cause
Check the unit is plugged in correctly and switched
on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Release the ON/OFF button, then unplug. Wait a
few minutes for the motor to cool down and the
thermal safety mechanism to reset, then restart
Release the ON/OFF button, then unplug. Re-install
the blade
Warning: Always ensure to
disconnect unit from power supply,
let it cool down and come to a
complete stop before cleaning.
After use, clean in time to prevent food from
sticking to surfaces.
Clean the power pack surface using a damp
cloth. Always wipe dry after cleaning. Never
immerse the motor part in water or rinse it
under running water.
Do not allow any moisture to enter the interior
via any ventilation slots.
The appliance contains on user serviceable
parts. A BUFFALO dealer or qualified technician
should carry out repairs if required.
Remove the food residue as much as possible.
Place the shaft and blade guard into a
container with water, then switch on for a few
seconds for thorough cleaning.
WARNING: Always dry the blades well after
cleaning to avoid spotting.
It is vital to clean thoroughly between each job
using a detergent or disinfectant, but never
use pure bleach. For plastic parts, do not use
detergents that are too alkaline.
Solution
2021/11/18 16:32 2021/11/18 16:32