Protocol Type; Set Max Ch And Set Dhw - Ferroli ROMEO N Manual De Usuario

Set the room temperature value that the Remote Control will regulate when the contact is closed (if parameter P8
has been set to 1) by pressing the buttons
temperature will change rapidly.
6. Press any other button to exit the menu.
Changing the Remote Control operation mode at telephone contact opening or closing can occur with a maximum time of 60
seconds.

3.11 Protocol type

Follow the instructions below to check the type of protocol used.
1. Press the button
2. The display shows parameter CU.
3. Press the button
4. Check that it is set to "1".

3.12 Set Max CH and Set DHW

Follow the instructions below to check if the heating and DHW set points can be both read and written in the boiler (0 = default),
or only written (1).
1. Press the button
2. The display shows parameter CU.
3. Press the button
4. Check that it is set to "1".
EN
134
for 3 seconds.
until parameter OT is displayed.
for 3 seconds.
until parameter FS is displayed.
code 3541Z220 - Rev. 05 - 12/2021
/ in 0.1°C increments. By keeping the button pressed the