Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS
1. Clearly hold the torque wrench with scale (A).
2. Pull out the folding adjusting wrench (B) at the knurling up to the joint
and fold it 90° to the side (see image above).
3. Set the required torque value by turning the adjusting wrench (B). The
currently set value can be read on the scale.
4. Example 560 Nm: Turn the adjusting wrench clockwise until the line in
the pointer (yellow) is on the 560 Nm line (500 Nm + 2 scale lines of 30
Nm).
5. Straighten the adjusting wrench and push it back into the housing.
6. Place a suitable tool (bit socket / socket) on the square.
7. Using the torque wrench, tighten the fitting slowly and evenly until a
clicking sound is heard, then immediately stop tightening.
MAINTENANCE
• From time to time, adjust the torque wrench from the lowest to the highest value, thereby
distributing the special internal lubricant to all components.
• The user is responsible for making sure that calibration and maintenance are carried out on a
regular basis.
CLEANING
• Clean the torque wrench with a dry cloth.
• Never immerse the torque wrench in cleaners or other liquids as the internal lubricant may be
affected and damage the torque wrench.
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and
packaging should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
@
o f n i
: l i
Tabla de contenido
