DeWalt DWX726 Manual De Instrucciones página 7

All manuals and user guides at all-guides.com
FIG. 7
C
N
TO RAISE AND LOWER THE STAND (FIG. 2, 8)
The stand has three positions: closed, fully extended and intermediate.
1. Turn the stand right side up on the floor.
IMPORTANT: Stand MUST be right side up when cutting white
cable ties (W).
2. Use wire cutting pliers to cut the white cable ties (W) shown in
figure 2.
IMPORTANT: DO NOT cut the black cable ties securing the
cables that open the stand.
3. Place your right foot on the bottom of the extension leg (E).
4. Grasp the handle (I) with both hands.
5. Use the thumb of your left hand to push down on the red activating
lever (V). This disengages the latching mechanism.
6. To reach the intermediate position: Lift up on the handle and
slowly raise the stand. The stand will stop at the intermediate
position. Release the lever.
NOTE: When in the intermediate position, the stand will lower
slightly when a tool is placed on it. The intermediate position does
not lock against upward motion. The stand relies on the weight of
the tool to remain in the intermediate position.
7. To fully extended stand: Start in the intermediate position.
L, M
Repeat STEPS 3-5. Lift up on the handle and raise the stand
to the fully extended position. The stand will latch in the fully
extended position. Release the lever.
8. To close stand: Repeat STEPS 3-5. Lift up on the handle and
push down until the stand is closed. Release the lever.
FIG. 8
5
I
V
I
V
E