FITFIU FITNESS GYM-200 Manual Del Usuario página 16

STEP 1
1. Attach the rear stabiliser (03) to the seat
support tube (04) and secure using 2 bolts (27),
2 washers (34) and 2 nuts (39).
2. Attach the upright support tube (02) to the
base frame (01) and secure using 2 bolts (30), 4
washers (35) and 2 nuts (39).
3. Attach the seat support tube (04) to the main
support tube (02) and secure using 2 bolts (30),
4 washers (35) and 2 nuts (39).
4. Attach the main support tube (05) to the seat
support tube (04) using 2 bolts (30), 4 washers
(35) and 2 nuts (39).
STEP 2
1. Slide the 2 guide tubes (07) through the
rubber rings (48) and through the two holes in
the rear stabiliser (03). Attach the tubes using
2 curved washers (33) and two bolts (22).
2. Carefully pass the 10lb weight plates (64)
over and down the guide tubes (07), so they
are located by the tubes.
3. Place the bushing (57) on the weight bar (19)
and connect them with the weight pin (41).
Then place the 8lb weight plates (63) at the
top of the weight bar (19).
4. Insert the weight pin (32) through the 10lb
weight plates (64) and the hole of the weight
bar (19)..
5. Attach the left cover bracket (72L) to the
rear stabiliser (03) and secure using 2 bolts
(76) and 2 washers (77). Perform the same
to attach the right cover bracket (72R) to the
right side of the rear stabiliser (03).
30
STEP 4
1. Pass the bolt of each backrest bracket (15) through the main
support tube (05) and secure using 1 washer (34) and 1 nut (39).
2. Attach the backrest (59) to the backrest brackets (15) and secure
using 4 bolts (24) and 4 washers (35A).
3. Attach the seat (60) to the mountings on the seat support tube
(04) and secure using 4 bolts (24)
and 4 washers (35A).
4. Attach the elbow pad (70) to the
elbow pad tube (68) and secure
using 2 bolts (24) and 2 washers
(35A).
5. Attach the elbow pad tube (68) to the
seat support tube (04) and secure
using the elbow tube knob (71).
6. Insert the rubber stop (52) into the
front side of seat support tube (04).
7. Attach the leg curl tube (06) to the
front of the seat support tube (04)
and secure using 1 bolt (29), 2 washers (36) and 1 nut (40).
8. Insert the leg curl pad tube (14) through the leg curl tube (06), then
attach the leg curl pads (54) to either end of the leg curl pad tube (14).
GYM-200
STEP 3
1. Insert the guide tubes (07) through the
bridge tube (08) and secure using 2 washers
(33) and 2 bolts (22)..
2. Attach the bridge tube (08) to the main
support tube (05) and secure using 2 bolts
(30), 4 washers (35) and 2 nuts (39).
31
EN