For Your Safety - Bosch GKS 75 S Manual Del Usuario

All manuals and user guides at all-guides.com
EURO • Printed in USA • BA 3 609 929 557 • GKS 75S/85S • GB • OSW 12/00
GKS 75 S/85 S.book Seite 11 Donnerstag, 30. November 2000 2:47 14

For Your Safety

Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed.
Before using for the first time,
ask for a practical demonstra-
tion.
If the mains cable is damaged or cut
through while working, do not touch
the cable but immediately pull the
mains plug. Never use the machine
with a damaged cable.
Wear ear protection.
Wear safety goggles.
The dust that is produced while
working can be detrimental to
health, inflammable or explosive.
Suitable safety measures are re-
quired.
Examples: Some dusts are re-
garded as carcinogenic. Use suita-
ble dust-/chip extraction and wear a
dust mask.
Never allow children to use the machine.
For long hair, wear hair protection. Work only
with closely fitting clothes.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Always direct the cable to the rear away from
the machine.
Insert the mains plug only when the machine is
switched off.
Before any work on the machine itself, pull the
mains plug.
Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
The machine must be operated only with the
appertaining protective devices.
The swinging protective guard 4 must be able
to move freely and close on its own accord; it
must not be clamped whilst it is open.
Always use the riving knife 7.
For stationary use, the machine may be oper-
ated only on a sawing table with restarting pro-
therein are tection.
Apply the machine to the workpiece only when
switched on.
Clamp the workpiece if it does not remain sta-
tionary due to its own weight.
When working, always guide the machine
away from the body.
Do not work with materials containing asbes-
tos.
The cutting path must be free of obstacles both
above and below.
The saw blade must not protrude more
than 3 mm out of the work piece.
Keep hands clear of the rotating saw blade. Do
not come into contact with the rotating saw
blade on the underside of the workpiece.
Do not allow fingers to enter the sawdust ejec-
tor 1.
Do not saw into nails, screws, etc.
Do not work overhead with the machine.
The saw blade and riving knife must not be-
come stuck in the cut. The saw tooth offset
must be wider and the main body of the saw
blade thinner than the thickness of the riving
knife.
Protect saw blades against shocks and im-
pacts.
Do not tilt the saw blade.
If the saw blade jams, switch off the machine
immediately.
After switching off, do not slow down the saw
blade by exerting side pressure.
Always switch off the machine and allow to
come to a stop before placing it down.
Use only sharp, flawless saw blades. Change
any cracked, bent or dull saw blades immedi-
ately.
Saw blades of highly alloyed, high-speed steel
must not be used.
Bosch is only able to ensure perfect functioning
of the machine if the original accessories in-
tended for it are used.
11