Using The Aura Professional; Making A Call; Direct Dial, Redial, Recall; Answering A Call - Spracht Aura Professional Manual De Usuario

USING THE AURA PROFESSIONAL

™

Making a Call

Place a call over an analog (PSTN) line

Direct Dial, Redial, Recall

1. Direct Dial
Press the PHONE button to get a dial tone. Dial the number. To cancel a
call in the process of dialing, press the PHONE button again .
Note: The Blue LEDs are always ON and the LCD shows PSTN on the
display. The microphones will only turn on after you have pressed any
number button in the process of dialing a number.
2. Redial last number
Press the REDIAL button. The last number called will be displayed and
dialed.
3. Redial a previously dialed number
While in stand-by mode, press one of the ARROW buttons, up or down,
to display previously dialed numbers on the LCD screen. Use the ARROW
up and ARROW down buttons to scroll through the list until you find the
number you need. Press the REDIAL button and the phone will dial.

Answering a Call

The Red LEDs will blink when the phone rings for
an incoming call. Press the PHONE button to
answer the call. The LCD will show PSTN.

Answering a Second Call

If there is another incoming call while you are on an existing call, you
will hear the Call Waiting tone. To answer the second call, press the
FLASH button . Your existing call will be placed on hold and you will be
connected to the second call. You can use the FLASH button to switch
between calls.
Note: This feature is based on your PBX system and may or may not be
available. The call waiting feature is also based on your individual system:
you should check with your telephone system administrator or service
provider.
Note: By default the FLASH time is set to 600ms.

Ending a Call

To end a call, press the PHONE button .
8