Installation Of The Ir Extension Cable With Emitter Leds; Locating The Ir Module; Connecting The Ir Module - Marmitek IR Control 10 Modo De Empleo

4.3.2

Installation of the IR extension cable with emitter LEDs

Place the LEDs from the IR extender cable precisely on the IR window (infrared
sensor) on the A/V equipment that you wish to operate.
Ensure that the IR extender cable's LEDs are stuck precisely on the A/V device's

infrared sensor (this can be extremely accurate on some devices). The exact
position can easily be located by shining a torch on the front panel and looking for
the IR sensor window.
All IR LEDs include self-adhesive film with which they are attached to your A/V

equipment.
 Test the position and the performance of the IR LEDs before you secure them to
the IR window on your A/V equipment.
If you use only one of the two LED's, leave the other IR LED unused. Never

remove it from the extension cable!
4.3.3

Locating the IR Module

Mount the IR Module at an accessible place behind or alongside your A/V equipment,
in the vicinity of an electrical socket.
Be aware of the cable length of the IR LEDs and the IR receiver.

Make sure the connections for installation remain accessible.

4.3.4

Connecting the IR Module

1. Connect the installed IR extension cables to the 'IR OUT' connector of the IR
Module.
2. Switch only the switches of the IR Module in BLASTER mode if an IR extension
cable with one blaster LED is connected. In any other case, leave the switch in
the EMITTER mode.
NOTE: a wrong choice between the two possibilities can cause damage to the IR
LEDs and they can even become defective.
3. Connect the installed IR receiver cable to the 'IR RCVR' connector of the IR
Module.
4. Connect the power adapter to the '12VDC' connector of the IR Module and
connect it to the mains.
IR Control 10™ 7