FITFIU FITNESS ROB-20 Manual Usuario página 29

ROB-20
ASSEMBLY
STEP 1
Unpack the product, fully unfold the legs and place it on a flat, horizontal surface. You can level the legs by adjusting
the height of the foot base pad to keep the bike roller stable.
STEP 2
In case your bicycle axle is compatible, insert the tyre
pressure adjustment knob into the buckle slot of the
resistance device and turn it to the lowest position.
Position the rear axle of your bicycle wheel in line with the
clamp and press down on the lock/unlock lever, then adjust
the knob on the other end to secure the bicycle. Then turn
the pressure adjustment knob until it touches the tyre.
STEP 3
If your bicycle axle is not compatible with the roller, remove
the rear axle from your bicycle wheel and install the supplied
quick release adapter.
NOTE: The quick release adapter is compatible
with 5 x 130 mm QR and 5 x 135 mm QR axles.
STEP 4
With the lock/release lever in the open position, position your bike on the roller, then close the lock/release lever to hold
the rear wheel of the bike and adjust the knob on the left
side slightly.
EN
29