Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Do not pull the cord to unplug the unit.
If you wish to open the tank, wait few minutes and
then unscrew the cap slowly to slowly release the
remaining steam from the tank until exhausting.
Do not use the ironing system as a heating unit.
Unplug the appliance before you fill or empty the tank.
CAUTION: the iron plate gets very hot during use, be
careful not to touch it, serious risk of burns. Do not
put your face near steam coming out the iron plate.
For correct boiler closing, press cap while rotating it.
At first use, remove the protective film of the plate; due to the presence of a protective oil and residues left
over from the film, the plate could emit some smoke. After few uses, the smoke will disappear. When using
the product for the first time, repeatedly use the steam (away from clothes) and try to use the iron on a
worthless piece of cloth to remove any manufacturing residues that may stain or scratch the fabric.
Thoroughly dry the clothes before iron them, do not iron over buttons and zippers.
We recommend the use of distilled water to avoid excessive fouling (not covered by warranty).
Do not fill the tank above the maximum capacity and do not introduce into the tank mixtures for removing
stain, vinegar, descaling agents or chemicals in general.
Use the appropriate refill cup to fill the tank of the boiler; do not fill it directly under the tap or with very cold
liquids. Always select the most suitable temperature according to the fabric to be ironed.
After ironing, drain all the water pushing the appropriate release button, empty the tank and wait for the
cooling of all parts before storing the system.
DESCRIPTION G40001
(1) Main unit/boiler
(4) Steam control knob
(6) Iron power on button and working light
(9) Water level control light
(12) Temperature control knob
INSTALLATION
Place the ironing system on a stable surface, away from heat sources. Unscrew the cap (15) and fill the tank
using the appropriate dispenser without reaching the maximum capacity of 1 liter. On first use, or after the
iron has been unused for a long time, it is recommended to expel the steam by pushing the button (13) for
about 20 seconds. This procedure allows to eliminate any working or limestone leftovers.
OPERATING THE IRONING SYSTEM
- Power on unit by placing the knob (5) to "1". The button will light up to indicate that boiler is heating up.
- CAUTION: when the tank control light (3) lights up, it means that the boiler is ready to produce steam.
During normal operation, the light lights on intermittently.
- The pressure gauge (2) indicates the pressure inside the boiler. The operating pressure is about 3 Bar.
- Turn on the iron by switching the knob (6) to "1". The button will light up to indicate that iron is running.
- Adjust the temperature using the control knob (12) according to the fabric to be ironed (see table at page 7).
The ironing temperature control light (14), placed on iron, will light to show when the iron is heating up.
- CAUTION: when this light goes off, it means that the iron has reached the desired temperature. During
normal operation, the light lights on intermittently.
Start ironing when the iron control light is off, and boiler control light (3) is turned on.
(2) Pressure gauge
(5) Boiler power on button and working light
(7) Insulating rubber base
(10) Power cord and plug
(13) Steam button
(3) Control light: "Steam ready"
(11) Continuous steam button
(14) Iron temperature control light
(8) Steam cord
(15) Cap
12
Tabla de contenido
