Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Universal Axle Cap and Groove Nut Wrench
SPECIFICATIONS
Inner square drive 20 mm (3/4")
Hexagon range: 70 - 150 mm
Groove nut range: 80 – 160 mm
DELIVERY
1 Adjustable wrench
2 Round bolt, 6 mm
2 Round bolt, 8 mm
2 Round bolt, 10 mm
2 Square bolts, 6 mm
2 Square bolts, 8 mm
2 Square bolts, 10 mm
INTEDED USE
This axle cap and groove nut wrench is used to loosen and tighten truck axle caps with octagonal and
hexagonal, groove nuts, face nuts, shaft nuts with holes, etc..
SAFETY INFORMATIONS
• Read carefully the instructions before working with this tool set.
• Do not use this tool set for other purpose for which it is designed.
• Keep your work area tidy and clean. Areas or corridors which are untidy increase the risk of
injury.
• Lifting of vehicles only allowed on the special lifting points.
• Before starting the work under a vehicle always ensure that it is adequately supported by axle
stands or ramps. Chock wheels and ensure that the hand brake is firmly applied.
• Always use approved eye protection, especially when working under vehicles.
• Ensure a secure and well-gripped stance during fitting.
• Check the condition of the tool regularly and do not use it if it is damaged.
• Make sure the tool is properly mounted.
• Do not over tighten the spindle or apply excessive force, as this may damage both the tool and
the component.
• The tool is not suitable for impact wrenches. The use of an impact wrench can rupture tool parts
and flying tool fragments can cause injury.
• This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
• Fetten Sie immer die Schraubengewinde, ehe Sie das Werkzeug verwenden.
• Keep children and other unauthorized persons away from the work area.
• Do not let children play with the tool or its packaging and keep this tool out of the reach of
children.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 6746
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
