Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cleaning and Maintenance
•
To reduce the chance of an accidental discharge, follow the
(on page 10) and
Marker
•
Eye protection must be worn.
•
Do not disassemble a marker while it is pressurized with air.
•
Do not pressurize a partially assembled marker.
•
Follow warnings listed on the air/CO2 cylinder for handling and storage.
•
Familiarize yourself with instructions listed on air/CO2 cylinder.
•
Contact the air/CO2 cylinder manufacturer with any questions.
•
Do not use any petroleum based cleaning solvents.
•
Do not use any cleaning solvents that come in aerosol cans.
: Petroleum based products and aerosol products can damage your marker's
NOTE
O-rings.
To clean the exterior of your paintball marker, use a damp towel to wipe off paint, grease,
and any debris. To clean the inside of the barrel, remove the barrel by unscrewing it from
the Upper Receiver. Insert the tab end of the cable squeegee into barrel. Pull the squeegee
through the barrel to remove debris and paint.
To maintain your marker in good working condition, inspect, clean, and replace any damaged
parts.
Every 8,000 to 10,000 shots, use Tippmann grease to lubricate specific areas (marked with a
G in the Parts Diagrams
to clean and grease these specified areas, it is unnecessary to disassemble your Phenom
marker for general maintenance. This maintains your marker in good working condition.
Inspect the air supply valve O-ring, and lubricate it with a little grease when attaching the air
supply cylinder.
Storage
Before storage, unload the marker (page 10) and remove air/CO2 cylinder (see page 14).
Ensure the Selector Switch is in Safe mode (see page 6) and the barrel blocking device is
installed (see page 4). Store your marker in a dry area.
When removing your marker out of storage, make sure to keep the Selector Switch in Safe
mode (see page 6) and keep the barrel blocking device installed (see page 4).
X7 Phenom Disassembly Instructions
Set up a workbench with plenty of workspace to make sure no small parts become lost.
Always wear eye protection when performing any marker disassembly or re-assembly. Refer
to the Parts Diagrams for these instructions (item numbers are in parentheses).
•
Follow
Unloading Your Marker
instructions on page 14.
•
Do not pressurize a partially assembled paintball marker.
Air/CO2 Cylinder Removal
) as instructed in the X7 Phenom Disassembly Instructions. Other than
on page 10 and
(on page 14).
Air/CO2 Cylinder Removal
15
Unloading Your
E
N
G
L
I
S
H
Capítulos
Tabla de contenido
