Makita 6922NB Manual De Instrucciones página 5

Ocultar thumbs Ver también para 6922NB:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

004987
Insert the outer and inner sleeves into the tool while
rotating the inner sleeve alternately clockwise and
counterclockwise until there is no gap between the outer
sleeve and the tool. See the figure below. Then tighten
the two screws securely.
004988
OPERATION
Bolt installation
Slip the tool onto the bolt so that the inner sleeve
completely covers the bolt tip.
004989
CAUTION:
Be careful when fitting the sleeve onto the bolt tip.
Striking the tip can damage it so that it will no longer
fit inside the sleeve properly.
Keep forward pressure on the tool while sliding it further
forward until the outer sleeve fits completely over the nut.
All manuals and user guides at all-guides.com
1. Outer sleeve
1
2. Pin
3. Inner sleeve
2
3
1. There should be
1
no gap between
the outer sleeve
and the tool.
2. Outer sleeve
3. Screw
2
3
1. Inner sleeve
1
2. Bolt tip
2
If the tool fails to fit completely over the nut, twist the tool
slightly right and left while pushing forward.
1
2
004990
Pull the switch trigger. The outer sleeve turns to begin
tightening the nut.
When the specified torque is attained, the bolt tip will be
sheared at its notched portion. The bolt tip will remain
inside the inner sleeve.
004991
Release the switch trigger and withdraw the tool in a
straight line.
004992
Press the tip ejector (tip lever) to eject the bolt tip from
the tool. Catch the sheared bolt tips to prevent them from
falling dangerously below. Keep the tips off of the ground,
floor, walkways, etc. to prevent injury from tripping or
falling.
1
004993
5
1. Outer sleeve
2. Nut
1. Notched portion
1
2. Bolt tip
2
1. Outer sleeve
1
1. Bolt tip
Tabla de contenido
loading

Tabla de contenido