Installation; Features Of The Appliance; Electrical Connection; Before Connecting Your Appliance - Fagor FIC-381E Manual De Instalacion Y Uso

3. INSTALLATION

FEATURES OF THE APPLIANCE

- This appliance is designed to operate correctly at room temperature according to its climate classification, which
is stated on the features plate located on the back of the appliance.
CLIMATE CLASSIFICATION
SN
N
ST
T
LOCATION
- The appliance must be installed on a flat, stable surface.
- When placing the appliance into the unit space, take care not to squash the mains cable. It is advis-
able not to use extensions or adaptors for connecting to the mains.
- Between the rear of the appliance and the wall, there must be a minimum distance of 20 mm and,
between possible future units hanging on the wall, a distance of 100 mm.
- Do not place any household electrical appliance which gives off heat on the appliance, such as:
ovens, microwaves, toasters, etc.
- If it is installed fully integrated, check that the aeration section in the kitchen unit is 200 cm
lation channel at the rear of the unit has a minimum depth of 50 mm. Please follow the instructions relating to the
integration (Section 1).
- Check that there are no electrical appliances or components near the aeration openings.
Attention:
Access to the mains must be ensured to help with unplugging when required. If this is not possible, connect the
appliance to the mains by means of a double-break switch with an opening distance for the contacts of at least 3
mm, situated in an accessible place.

ELECTRICAL CONNECTION

- The appliance must be earthed in accordance with the law. The manufacturer cannot be held
liable for any incidents caused by failure to comply with this.
- Make sure that the voltage stated on the appliance's features plate, located inside on the left-
hand side, corresponds to the voltage for the wiring in the house.
- Do not use adaptors or extensions.
- Prevent the cable from coming into contact with the motor.
- Prevent the cable from being trapped under the appliance.

BEFORE CONNECTING YOUR APPLIANCE

When the appliance is fully installed, the following is recommended:
- Clean the inside with warm water and bicarbonate of soda. Rinse and dry carefully.
- Wait 2 hours before starting up to ensure the stabilisation of the motor lubricants.
- Plug into the mains.
All manuals and user guides at all-guides.com
ROOM TEMPERATURE
+10°C a +32°C
+16°C a +32°C
+18°C a +38°C
+18°C a +43°C
46
3
and that the venti-