Box Contents; Securing The Dolly - Elcometer 506 Guia Del Usuario

2 BOX CONTENTS

Elcometer 506 Adhesion Tester

Standard Epoxy Adhesive (2x15ml tubes)

Abrasive Pad

2 x AA Batteries

Transit Case

Test Certificate

Calibration Certificate

User Guide

Additional items in 20mm Kit:
20mm Dollies (x10)

20mm Dolly Standard Skirt

20mm Dolly Cutter & Handle

Additional items in 50mm Kit:
50mm Dollies (x6)

50mm Dolly Standard Skirt

50mm Dolly Cutter with Drill Arbor


3 SECURING THE DOLLY

3.1 USING 14.2mm OR 20mm DOLLIES
1 Prepare the surface of the dolly and the coating where the dolly is
to be applied by roughening with the abrasive pad. Then
de-grease and clean both surfaces using a suitable solvent and
allow to dry.
2 Mix equal quantities of the two part Araldite adhesive and apply
a thin, even layer to the prepared surface of the dolly.
®
 Araldite adhesive is supplied by Elcometer however, other adhesives can
be used - see Section 12 'Adhesives' on page en-13.
3 Press the dolly firmly onto the prepared test surface and apply
pressure to squeeze out excess adhesive which should then be
wiped clean.
4 Allow the adhesive to cure - see Section 12 'Adhesives' on page
en-13.
 If testing on vertical surfaces, you may wish to tape the dolly in place
during cure.
5 If required, score the coating around the dolly using the dolly
cutter provided.
en-3
R
(digital gauge only)
(if ordered)
®
www.elcometer.com