Adhesives - Elcometer 506 Guia Del Usuario

11 SPARES & ACCESSORIES (continued)
Description
Standard Skirt
Thin Substrate Skirt
Thin Substrate Skirt
Standard Skirt
Part Number
T9991420S
T9990014T
T9990020T
T9990050S
11.4 MAGNETIC ANCHOR CLAMP
Ideal when testing at height or on vertical
surfaces to prevent damage to the surrounding
coating or harm to the user, the magnetic
anchor clamp connects to the lanyard ring on
the top of the actuator to prevent the actuator
from falling when the dolly is pulled from the
substrate.
Description
Magnetic Anchor Clamp Accessory

12 ADHESIVES

The adhesive supplied with the Elcometer 506 is Araldite Standard, a
two-pack epoxy paste which is mixed from approximately equal
volumes of the two components. Measurement by eye is sufficient.
When mixed it should be used within one hour. Curing Times:
24 hours at 25°C (77°F); 3 hours at 60°C (140°F)
®
Araldite is suitable for warm and hot environments. Lower
temperatures can require extended curing times of up to 3 days or
more. The expiry date of the adhesive should be checked before use.
Adhesive which has expired should not be used.
Unused adhesive must be disposed of as special waste unless it has
been fully cured. To dispose of excess adhesive at the end of its shelf life
simply mix the remaining material and allow it to cure before disposal.
†
I/D: Inner Diameter
en-13
R
For Dolly Sizes (mm)
14.2 & 20mm
14.2mm
20mm
50mm
Integrated Support Ring Dimensions
†
I/D
30mm
16.3mm
21mm
52mm
‡
O/D: Outer Diameter
Part Number
T9991420S
T9990014T
T9990020T
T9990050S
‡
O/D
40.4mm
40.4mm
40.4mm
72mm
Part Number
T99923797
®
www.elcometer.com