After Test; Digital Pressure Gauge Features & Functions; Fitting The Batteries - Elcometer 506 Guia Del Usuario

8 AFTER TEST

8.1 ANALOGUE PRESSURE GAUGE
1 Fully unwind the crank handle and coarse adjustment screw
(anti-clockwise) to decrease the pressure to zero.
2 Pull up the quick connect coupling to release the dolly.
8.2 DIGITAL PRESSURE GAUGE
1 Fully unwind the crank handle and coarse adjustment screw
(anti-clockwise) to decrease the pressure to zero.
2 Pull up the quick connect coupling to release the dolly.
3 Press
MAX
4 Press
MAX
Note: Failure to release the 'Max Hold' and zero the gauge before each adhesion test
will result in an invalid adhesion measure.
9 DIGITAL PRESSURE GAUGE FEATURES & FUNCTIONS
Read this section if you are using an Elcometer 506 Adhesion Tester
fitted with a digital pressure gauge.

9.1 FITTING THE BATTERIES

1 Peel the protective rubber boot forward to expose the battery
compartment cover at the rear of the gauge.
2 Rotate the battery compartment cover anti-clockwise to the
'unlock' position.
3 Identify correct polarity and fit 2 x AA alkaline dry batteries.
4 Replace battery compartment cover and rotate clockwise to the
'lock' position.
5 Replace protective rubber boot taking care not to damage the
front panel of the display.
The battery symbol at the bottom right hand side of the display
indicates the battery condition.
Note: Batteries must be disposed of carefully to avoid environmental contamination.
Please consult your local Environmental Authority for information on disposal in
your region. Do not dispose of any batteries in fire.
en-9
R
to release the 'Max Hold'.
again to zero the gauge and reset 'Max Hold'.
www.elcometer.com