Wall Bracing
(2x6 minimum)
C L
Finished
Floor
1. Prepare the Site
Rough-in the water supply lines and the drain piping.
Install a minimum of a 2x6 as a wall brace to provide support for
the wall bracket. The brace should be the same length as the
console table, 36" (91.4 cm) and should be positioned 32"
(81.3 cm) from the finished floor to the top edge of the board. The
center of the wall brace should be in-line with the drain outlet.
Finish the wall.
Mark the centerline on the floor and the wall.
Mark the anchor holes on the wall for the towel bar mounting
brackets.
Mark the anchor holes for the console table mounting bracket on
the wall by holding the bracket up to the finished wall so that the
center of the bracket lines up with the centerline. Mark the
location of the anchor holes with a pencil.
Mark the location of the holes on the floor for the feet anchors.
Kallista
Finished
Wall
Towel Bar
Bracket Anchor
Holes
32"
(81.3 cm)
26-3/4"
(67.9 cm)
18-7/8"
(47.9 cm)
3
Console Table
Bracket Anchor
Holes
Mark the
anchor holes.
Foot
Anchor
Holes
C L
14-3/4"
(37.5 cm)
1021663-2-A