Idiomas disponibles
Idiomas disponibles
5. Remove either top or back wiring knockout and install
approved Electricam Cabme CmamJo,
/
if hood is to be installed Non-Ducted:
e Purchase
a CmeanCooking
Fimter and attach it to the
aluminum
mesh filtero
e Skip to "CONNECT WiRiNG"
section on page 9,
See page 4 for Cmean Cooking
Filter information.
Clean Cooking
Fimter available
by calling Sears
at 1-800o4-MY-HOME ®
ELECTRICAL
CABLE CLAMP
The following
Steps (6 thru 13) are for
DUCTED
INSTALLATION
ONLY.
(3) #8 SCREWS
LIGHT
PANEL
6.
Remove _ht
Panel - held in place with (3) #8 screws
and (2) #8 screws. Disconnect light assembly wire
harness (white connector).
7.
Remove Air Chute - held in place with one (1) scre_
NOTE: Be careful not to disconnect any wires.
AiR CHUTE
\
\
\
8.
Remove Baffle from air chute.
BAFFLE
BAFFLE
\
