Idiomas disponibles
Idiomas disponibles
©
LOW
HIGH
LOW
HIGH
FAN
LIGHT
iNDiCATOR
LIGHT
Fan
The 3-position rocker switch (on the left) controls the fan. The
left position is Iow speed, center position is off, and right posi-
tion is high speed. An indicator light shows that the fan is on.
Light
The 3-position rocker switch (on the right) controls the lights.
The left position is low light intensity, center position is off, and
right position is high light intensity.
WARNING: To reduce the risk of electric shock,
disconnect
from power supply before cJean-
rag.
ABuminum mesh filters
Clean frequently using hot water and a mild detergent or in
your dishwasher. The aluminum mesh filters should be washed
approximately
every month depending
on the amount of us-
age. Wash more often if your cooking style generates greater
grease - like frying foods or wok cooking.
Nonoducted
filters (Cmean Cooking
hoods onmy)
(available separately - see page 4)
Clean filter surfaces frequently with a damp cloth and a mild
detergent.
DO NOT immerse filters in water or put in dish-
washer. The special "Clean Sense" feature indicates when the
filter is to be repIaced. The blue and yel!ow strips will blend to
green when it is time to change the filter. The "Clean Sense"
feature works best when facing toward the cooking surface.
Painted hood surfaces
Wiping regularly with mild soap/detergent
and warm water
should protect painted hood surfaces. Be cautious about us-
ing "New and improved" cleaning agents. Your hood is installed
over hot cooking equipment.
Most chemicaIs found in clean-
ing agents react with heat to loosen paint.
Stainless
steem hood surfaces
Stainless steel hoods should be washed regularIy with a clean
cloth, warm water and mild soap or dish detergent. Clean in
the direction of the polish Iines. Rinse well with clear water
and wipe dry immediately. You may wish to apply light oil used
for furniture polishing to emphasize it's bright finish.
Fan assembmy
Fan blade can be cleaned with a damp cloth and mild deter-
gent. Use care when cleaning fan blade - it must not become
bent or misaIigned.
DO NOT ALLOW WATER TO ENTER
MOTOR. Make sure alI surfaces are completely dry before re-
installing filters and restoring power.
Motor is permanently
lubricated.
Do not oil or disassemble
motor.
q_
{b
q_
2
3
