Phonic AM844D Manual Del Usuario página 10

MASTER SECTION
36
37
39
36. AUX Return 1 and 2 Controls
These controls adjust the signal level of audio fed through to the
stereo AUX Return inputs. The "To AUX Send 1" and "To AUX
Send 2" controls adjust the pre-fader level of the signal from the
AUX Return controls to the corresponding AUX mixing buses for
effect-to-monitor sends.
37. EFX Return Control
This control adjusts the signal level of audio fed through to stereo
AUX Return 3 inputs. If no device is plugged into the AUX Return
3 inputs, it then acts as the final level control of the built-in Digital
Effect Engine.
38. Main L/R - Group Buttons
The first of these buttons changes the destination of the signal
sent from the AUX Return 3 mixing buses between the Main L/R
and Group mixing buses. The second button works when the
user selects to send the signal "To Group", allowing the signal to
be sent to either Group 1-2 or Group 3-4.
39. AUX Return 4 Control
This control adjusts the signal level of audio fed through to the
stereo AUX Return 4 inputs. The accompanying "C-R Phones
Only" button allows users to send the signal to the Control Room
/ Phones mixing bus for monitoring purposes.
40. Solo Returns Button
Pushing this buttons allows you to send the signal from all AUX
Returns to solo mixing bus (which is, intern, send to the Control
Room / Phones mixing bus). When the Solo is activated, the
corresponding LED indicator will illuminate.
6
All manuals and user guides at all-guides.com
36
38
40
41
41. AUX Send Master Controls
These controls adjust the final level of the AUX 1, 2 and 3/4
signals (as taken from the AUX 1, 2, 3 and 4 level controls on each
channel strip), the audio of which is sent to the corresponding
AUX send outputs. The SOLO buttons accompanying these
controls allow you to send the AUX send signals to the Control
Room / Phones mixing bus for monitoring purposes.
42. AUX Solo Buttons
Pushing one or more of these buttons allows you to send the
signals from the AUX 1, 2 or 3/4 mixing buses to the Control
Room / Phones mixing bus.
43. Solo Mode Button and Indicator
This button alternates the solo source signals between those of
post-fader (normal) and pre-fader feeds (level set), to be sent to
the Control Room / Phones mixing bus. When the Solo indicator,
located beside the Level Meter, is illuminated, one or more Solo
buttons has been pushed; therefore the Level meter will display
properties of the Solo signal, which is helpful with setting of
channel properties. If the Solo indicator illuminates green, this
means the Solo feed is a pre-fader signal. If the solo indicator
illuminates red, the feed is post-fader. If no Solo buttons are
activated, the Control Room / Phones selected sources (Main
L-R, Group 1-2, Group 3-4 and/or 2T Return) signal properties
are displayed by the Level Meter. In this case, the Level meter
will display the sum of the selected signals.
44. 2T Return Controls
Turning the 2T Return level control adjusts the signal level of
the feed from the 2T Return inputs. The "to Main L/R" button
that accompanies this control allows users to send the 2T return
signal to the Main L-R mixing bus. When this is done, the 2T
return signal is not sent to the Rec Out, as to avoid producing a
feedback loop when recorded signals are fed back into the 2T
return.
45
46
42
44
43
AM844D