Observe Flame
Height When Lit
Flame should be blue and yellow in color and
approximately 1/2 in. - 1 in. (1.2 cm - 2.54 cm) tall on
HI setting.
Temperature Management
Manage desired heat for cooking by adjusting burner knobs from LOW to HI. Weather conditions may
cause heat fluctuations and require more heat in cold and/or windy conditions. Different types and
amounts of food will also impact your temperature management and distribution. Being aware of all
elements will help ensure optimal gas appliance performance and desired cooking results.
Disconnecting the
LP Cylinder
1. Turn all control knobs to the OFF position.
2. Turn the wheel on the LP cylinder clockwise until it stops.
3. Turn coupling nut on regulator in a counterclockwise direction
until the regulator is released from the threaded LP cylinder
valve nozzle.
4. Place the protective cap over LP cylinder gas nozzle.
LP Cylinder
The LP cylinder should not be dropped or handled roughly! If the appliance is not in use, it is
recommended to disconnect the LP cylinder. Replace the protective cap on the LP cylinder after
disconnecting the LP cylinder from the appliance.
LP cylinders must be stored outdoors in an upright position and out of the reach of children. The LP
cylinder must never be stored where temperatures can reach or exceed 122°F (50° C). Do not
store the LP cylinder near flames, pilot lights or other sources of ignition. DO NOT SMOKE NEAR
AN LP CYLINDER.
Again, this outdoor stove is designed for outdoor use only and away from any flammable materials.
Ensure there are no overhead obstructions and no objects/barriers are within 36 inches (90 cm) of the
outdoor stove. Ventilation openings of the outdoor stove should not be obstructed at any time. The
outdoor stove must be used on a level, stable surface, positioned away from direct drafts and protected
against water exposure (e.g. rain).
Parts sealed by the manufacturer or its agent must not be altered by the user.
No modifications should be made to any part of this outdoor stove. Repairs and
maintenance should only be carried out by a registered service engineer or technician.
C-8
High
Low