Lighting Instructions
When lighting, keep your face and body as far away from burners as possible and never lean over
outdoor stove surface. If outdoor stove does not light immediately or goes out during operation, turn all
burner knobs to the OFF position and wait 5 minutes for gas to clear before attempting to relight.
Failure to do so may result in an explosive flare-up, which can cause serious bodily injury or death.
After achieving a successful lighting and prior to first use, allow the outdoor stove to run on HI for
at least 15 minutes. This process will ensure no performance issues and allow the outdoor stove to
self-clean and sanitize.
Main Burners
Your Char-Griller
outdoor stove is equipped with three (3) individual
®
cast-aluminum burners. Each is controlled and lit by their own individual
knob and integrated ignition.
1. Make sure all burner knobs are in OFF position.
2. Open valve on LP cylinder by turning wheel counterclockwise.
3. To ignite a burner, push in and rotate knob counterclockwise towards
"HI" until you hear a loud click and the burner ignites. If burner does
not light immediately, turn burner OFF, wait 5 minutes for gas to clear
and repeat Step 3.
4. Repeat for all desired burners. Light only burners intended for use.
5. Adjust knobs to desired cooking setting.
After lighting, observe burner flame and make sure all burner ports are lit.
Shutting off Burners
1. Turn knob(s) clockwise to LOW position, then push in and turn to OFF. Never force knob without
pushing in, as this can damage valve and knob.
2. Promptly close LP cylinder valve by turning wheel clockwise.
C-6