Package Contents; Installation Requirements; Direct Mounting - Bodypoint LH600S Instrucciones Del Usuario Y De Instalación

PACKAGE CONTENTS

• Leg Harness
• Cinch-Mount™ or Flat-Mount™ End Fittings
• FrameSaver™ Clamps (Optional – Art No, FS032-2)
ORIENTATION
Seat user in wheelchair and
establish correct posture. Place Leg
Harness pad against inner thigh
with rear strap end passing near
the pelvis and hip joint. Pad should
touch the seat, but not extend
under the leg or touch groin area.
ADJUSTMENT
Tighten Leg Harness on user with D-ring
strap. Remove any extra slack from web-
bing at rear end fitting. When properly ad-
justed and the straps tightened, it should
fit snug so the user's legs are secure.
Ø 1" (25mm)
REAR STRAP
1. Rear straps should be
anchored to the rear
of the seat rail
2. Locate desired anchor
point and attach end
fittings to wheelchair
frame.
Ø 3/16–1/4" (5–6mm)

INSTALLATION REQUIREMENTS

• #2 Philips screwdriver.
• Mounting screws with a minimum pullout strength
of 200lbs /90kg. Not included in package.
Ø 7/8" (22mm)
Ø 3/4" (19mm)
(Art. No.
HW303-19SHIM)
FrameSaver™
FRONT STRAP
1. Pass the strap under the thigh, and
locate desired anchor point at front
of seat rail or under seat.
2. Attach end fittings to wheelchair frame.
SAFETY CHECK
When properly positioned in wheelchair, have user lean
forward and side to side to check fit. Check for:
1. Normal operation of buckles and adjustment straps.
2. Comfort–Look for areas of irritation.
3. Interference with other devices–Relocate anchor points
as necessary.
4. Move chair through full range of motion, including tilt,
folding, and rolling. Check for any interference.
#2 Phillips
Cinch-Mount™ Flat-Mount™

DIRECT MOUNTING

End fittings can be attached
directly to solid seat
surfaces. Mounting screws
must have minimum pullout
strength of 200lbs/90kg.
(Not included in package.)
en