LF Harbor Breeze GAT24BNK6L Manual Del Usuario página 8

INITIAL INSTALLATION
5. Remove preassembled motor screws/lock washers
(Q) from underside of motor housing (D). If there
are plastic motor blocks installed with the motor
screws/lock washers (Q), discard the plastic motor
blocks.
Note: Make sure to keep loose hardware separate
to avoid confusion during installation.
6a. Remove pin (L) and clip (M) from downrod (A).
6b. Partially loosen preassembled set screws and nut
in motor housing yoke at top of motor housing (D).
Insert downrod (A) through canopy (B), canopy
7.
cover (J) and yoke cover (E). NOTE: Canopy
cover (J) must be turned with the shiny side
toward the motor housing (D).
Then, thread wires from motor housing (D)
through downrod (A).
5
D
6a
M
D
7
8
J
K
6b
A
L
Set Screw
Yoke
A
B
J
E
Plastic
Motor
Block