Orbegozo CTP 1930 Manual De Instrucciones página 11

CTP 1930
Use tips
HAIR:
 Should be dry and free of lotions or other liquids.
 Comb outward with the head 6 and guide-combs to obtain maximum
height/length and facing in the same direction. Until you become familiar
with hair clipper it is recommended to use the longer measuring guide-
combs first.
BEARD/MUSTACHE:
 Use guide-comb with hair clipper for beard.
 Starting under chin, ascend along the cheek in the direction of the ear.
Measure in different directions to cut all the isolated hairs.
 To lighten or trim the beard, use a small level so that the hairs do not
bend. With the help of the opposite hand, hold the clipper -sharp cutter
to the outside- while slowly sliding the appliance along the head.
SHAVER:
Use the shaver attachment to clean-up detailed areas. For best results, avoid
holding at an angle.
EARS:
 When trimmer inner ears, avoid inserting Grooming System more than 1/4"
into ear canal.
 Rotate Grooming System in a circular motion while gently moving in and out
of ear canal.
NOSE:
 Insert the hair clipper delicately (accessory 3) and do not put the device more
than 1 cm inside the nose.
 Apply a rotating movement to the device during insertion and removal from
the nose.
CLEANING, CARE & MAINTENANCE
NOTE: Always clean Grooming System attachments regularly to ensure best performance and a proper
operating life.
CLEANING ATTACHMENTS WITH WATER
1. Remove attachment.
2. Rinse ONLY the attachment under warm running water. DO NOT use hot water ad this might cause
damage.
CLEANING ATTACHMENTS WITH BRUSH
 After first removing attachment, thoroughly brush and blow out hair clippings from cutting system,
attachment, and top of power handle.
11