Tabla de contenido
Idiomas disponibles
Idiomas disponibles
preparation:
Set the tap to "cold" and let the water run. Close
the valve of the cold water wall connection in a-
clockwise direction until no more water comes
out of the tap. To be on the safe side, have a
towel and a bucket ready in case any residual
water drips out.
Variant A - with existing fitting:
13. remove the cold water hose of the tap on the
cold water valve of the wall and screw on the
inlet hose of our filter.
14. now screw the free hose of the tap onto the
outlet hose of our filter.
15. unscrew the cold water connection on the
wall again and carry out a short leak test, if
necessary tighten the connections slightly.
6. r
1
inse the filter for approx. 8-10 minutes with
the tap fully turned on.
17. your filter is now ready for use!
Variant B with additional tap and variant C with special 3-way tap should only be installed by an
authorised specialist!
The installation of a water filter and the annual change of the cartridge are a good opportunity to clean
the aerator in the tap and replace it if necessary!
Technical data
Min. flow rate:
Max. Pressure:
temperature:
Filter capacity:
Cartouche:
connection:
Installation dimensions:
Conformity:
4.5 l /min at 7 bar (with new cartridge)
8.0 bar
min. 3 °C - max. 38 °C
11,200 litres or max. 12 months (whichever comes first)
Anti-calc activator, sintered activated carbon block 0,3μm, micro-membrane system 0,1μm
3/8"
400 mm x 170mm x 120mm (height x width x depth)
EU Regulation 10/2011, European Directive 98/83/CE, DM 25/2012, DVGW (W543),
KTW-A, W270. Our filter fully complies with EU regulations for materials that come into
contact with food and drinking water.
14
Tabla de contenido
