Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Step by step assembly instructions
Insert the cartridge and prepare the filter:
1. mark the installation date on the label
2. remove the protective cap from the cartridge
3. Grease the O-rings of the cartridge with a little
cooking oil.
4. determine the flow direction of the water
through the
triangles
on top of the filter head
The backflow preventer is located on the inlet
side of the filter head.
5. the filter head is supplied pre-assembled.
Please check the connections and tighten only in
case of leakage.
.
6
Place the filter head loosely on the cartridge
and turn it back and forth until the filter head
sinks in slightly.
.
7
Now apply light to medium pressure from
above on the filter head until it sinks about 1 cm.
8. the filter head must have the same distance
from the white ring of the cartridge everywhere.
.
9
Now screw the cartridge into the filter head in
the direction of the
green arrow
locking lever snaps down slightly. Now the filter is
ready to be inserted into the cold water flow.
0.
1
Mark and drill the two holes with the drilling
template (back of this manual).
11. tighten the screws only until the wall bracket
can be easily hooked into the slotted holes.
12. hang the fully assembled filter with the wall
bracket. The filter should always be easily
unhooked without tools.
until the red
13
OUT
IN
Tabla de contenido
