Safety Warnings - IARP VIC 4SK Instrucciones De Empleo Y Manutención

SAFETY WARNINGS FOR THE APPLIANCES USING
R290 COOLING FLUID (PROPANE)
Propane is a natural gas that doesn't affect the environment but is inflammable. It is therefore
indispensable to check that the cooling circuit tubing is not damaged before connecting the equipment
to the mains. For every 8gr. of cooling fluid, the installation location must have a minimum volume
of 1 cubic metre. The amount of cooling fluid in the appliance is indicated on the technical data plate
on the back. Leakage of cooling fluid: avoid naked flames or over sources of ignition at the seat of the
leakage. Be careful not to damage the cooling fluid circuit during positioning , installation or cleaning.
Warning! Be careful not to damage the cooling fluid circuit.
Warning! Avoid flames or sparks inside the equipment.
Warning! In case of damaged cooling fluid circuit, do not start the machine and refer to a service centre.
Warning! Keep clear of obstruction all ventilation openings in the appliance enclosure or in the
structure for building-in.
Warning! Do not use electrical appliances inside the food storage compartment of the appliance, unless
they are of the type recommended by the manufacturer.
Warning! Do not store explosive substences such as aerosol cans with flammable propellant in this aplliance.

SAFETY WARNINGS

- Read this section carefully before installing and using the equipment and always follow the
instructions in it.
-
Always keep the instruction manual and, if you sell the equipment, hand it over to the new owner.
- This appliance is extremely dangerous if left exposed to rain, storms and bad weather in general
with the power cable plugged into a mains outlet.
- Never touch or move the appliance with bare feet or wet hands or feet.
- Packaging materials such as plastic bags, polystyrene and plastic tapes must be kept out of reach
of children as they are potential sources of danger.
- Don't allow children to play with the appliance (for example by sitting in the baskets or climbing
on the hatch), as this may cause it to tip over or cause objects on top of the freezer to fall off.
- Having installed the equipment, make sure it's not resting on the power cable.
- To disconnect the equipment from the mains supply, remove the plug but don't do this by pulling
the cable.
INSTALLATION
Remove the packaging completely; clean the cabinet using
warm water with a 5% concentration of neutral soap.
Be sure to use a soft cloth for drying. Keep a distance
from the wall of 10 cm at least. Note that only specific
product can be used for the glass, e.g. some types may
leave behind limestone residues. Cabinet must be installed
on a perfectly even surface (settle the adjustable feet or
with the wheels locked),far away from any heat source
(radiators, stoves, etc) including sun rays. Good running
of the cabinet can be compromised in cases where the
airflow is disturbed (wind, ventilators, air conditioning
outlets, etc). Smooth running of the cabinet is assisted
when sufficient air is permitted to flow through the bottom
of the unit; it is very important that the grills at the base
are kept uncovered.Do not expose the cabinet to rain.
INFORMATIONS ABOUT USE
-8-
ENGLISH