IARP VIC 4SK Instrucciones De Empleo Y Manutención página 10

WARNING
If the appliance is installed in damp, not-heated premises, droplets of condensation may form
on the outside surfaces (side, back, windows).
This would happen typically between season, when ambient temperatures are relatively low and hu-
midity is high, and is a perfectly natural phenomenon having no effect on the working of the freezer.
DEFROSTING AND TANK CLEANING
If , however, the layer of frost on tank walls exceeds 4/5 mm in thickness, you should completely
defreeze the appliance as follows:
1) Place the goods in special refrigerated containers, kept at the same temperature.
2) Unplug the unit.
3) Leave the covers open and begin the operation of washing when the tank temperature is the same
as the ambient temperature.
4) Remove the internal draining plug and place under the body (if it's possible) a tray for water discharging.
5) Wash and dry the tank using a soft cloth and neutral soap. Subsequentely, replace draining plug, plug
in again and wait till the appliance reaches the right temperature before filling it again.
Do not use jet of water or steam to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process, other than
those recommended by the manufacturer.
SEASONAL USE
When the unit is kept unused for a long time, please take note of the following procedures:
- unplug the unit;
- clean and dry well the tank;
- leave the covers half open to prevent bad smells forming;
- cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
MALFUNCTIONS AND REMEDIES
Most of the functioning inconveniences are generally due to simple causes or to defective electrical
connections. These problems can usually be solved on site.
The unit does not start:
- check that there is voltage at the wall socket;
- check that the unit is properly plugged;
- check that there is voltage at the wall socket;
The internal temperature is not cold enough:
- check that the unit is not placed too close to any heating source;
- check that there is not too much ice on the tank walls;
- check the thermostat position;
- check that the condenser is not blocked by dirt.
- check the covers closing.
The unit is noisy:
- check that all the bolts and nuts are properly fastened;
- check that the unit is placed on an even surface;
- check if any pipe or fan is in contact with any other part of the body.
INFORMATIONS ABOUT SERVICE
-10-