Zolia Free Chick Manual Del Usuario página 3

Connect the motor connection wire connector to the corresponding position on the circuit board. Then use
➢
four M4 X 30 flat head screws to screw the front panel to the control box.
Install the assembled device above the door. The distance between the bottom of the device and the top of
➢
the door when open should be approx. 10-12 cm, as shown in the below diagram. Secure it with the four tapping
screws. Installation is now complete.
PANEL INTRODUCTION
❏
A - Time
B - Height calibration
C - Manual
D - Timer
E - Sensor
F - Mix
G - Battery level
H - Open and close state
I - Digital display
J - Warning
K - Up
L - Menu
M - Down
1 -Open state
2 - Close state
3 - Opening
4 - Closing
3