Uline H-7100 Manual Del Usuario página 4

3. Using a sharp blade or scissors, slowly cut the
weather insulation board to a size that will fit the
inside curtain rails and completely cover the curtain.
4. Once properly sized, remove the backing to expose
the adhesive tape.
5. Place the weather insulation board over the left
curtain and firmly press and hold for five seconds.
(See Figure 6)
Figure 6
Weather Insulation Board
6. Repeat steps one through five to install on right
curtain.
PLACING THE UNIT INSIDE A NORMAL WINDOW
1. Set the unit in the window so that it is centered.
Place the unit so that front edge of the bottom rail is
against the back edge of the sill.
2. Bring the window down so that the front edge of the
top rail is in front of the window. Be sure the unit is
tilting slightly to the outside. (See Figure 7)
Figure 7
Top Rail
3. Once the air conditioner is placed, extend the left
and right curtains to the width of the window.
PAGE 4 OF 27
INSTALLATION CONTINUED
Window
Frame
1/4"
Bottom Rail
4. Place the curtain lock between the curtain
extensions and the window sill, drive two long screws
through the lock and into the sill. (See Figure 8)
Figure 8
Foam Seal
Sash Lock
Window
Sill
Curtain
Lock
5. Secure the left and right flanges on end bottom side
of the curtain with long screws. (See Figure 8)
6. Drive two long screws through two upper frame
holes into window sash. (See Figure 8)
7. Attach the sash lock to the place between the upper
and lower sashes and secure it with long screws. Each
side uses two long screws. (See Figure 8)
8. Cut the foam seal to the window width and insert
the sash seal between the glass and the window to
prevent air and insects from getting into the room.
(See Figure 8)
9. For added insulation, the insert strip can be inserted
between the air conditioner and window sill. This is
optional.
REMOVING AIR CONDITIONER FROM WINDOW
1. Turn power off and disconnect power cord.
2. Remove sash seal from between windows and
unscrew sash lock.
3. Remove screws installed through frame and frame
lock.
4. Close the side panels into frame.
5. Keeping a firm grip on air conditioner, raise sash
and tilt air conditioner backward to drain any
condensation in base of unit. Be careful not to spill
any remaining water while lifting air conditioner from
window.
6. Store air conditioner and parts in box.
Curtain
Flange
0621 IH-7100