Uline H-7883 Manual Del Usuario página 3

Figure 8
OPENING THE COVER
Key is taped to back of dispenser.
1. Insert forked end of key into two slots at top of cover.
2. Push down on key and pull forward on cover.
NOTE: Opening the cover removes battery
power from control circuit.
INSTALLING BATTERIES
1. Open cover. The battery compartment is located at
the front lip of the dispenser. The cover to the battery
compartment is removed by pushing the left hand
tab inward and lifting up. (See Figure 9)
2. Insert four "D"-size alkaline batteries with "LR20"
designation.
(Battery orientation is embossed on compartment.)
NOTE: We do not recommend using
rechargeable "D"-size batteries.
This dispenser is equipped with patented Paper Saver
technology.
OPERATING ISSUE
Unit will not dispense.
PAGE 3 OF 9
LOADING CONTINUED
2s
PAPER SAVER TECHNOLOGY FEATURE
TROUBLESHOOTING
RECOMMENDATIONS
Ensure cover is closed and securely latched.
Replace batteries if LED indicator light is flashing.
Make sure batteries are installed and oriented properly.
Remove and re-install batteries.
6. Firmly close dispenser and wait two seconds.
(See Figure 8)
7. The stub roll will continue to dispense paper until the
last 15 feet, at which time the main roll will begin to
feed. During this transition both rolls will feed paper
until the stub roll is empty.
OPERATION
Figure 9
3. Red LED will flash one time after the batteries are
installed and the cover is closed to indicate that the
unit is powered on and initialized.
4. When battery power is low, the LED will flash once
every 1.5 seconds continuously when the batteries
need replacement.
The Paper Saver technology decreases the second
sheet of paper by 10% when the dispenser is activated
within three seconds of a previous dispense.
1-800-295-5510
uline.com
0721 IH-7883