End Of Cycle Signal - Alliance Laundry Systems Speed Queen 800795 Manual De Instrucciones

Timer
Although the washer cycles are automatic, the timer may
be reset to lengthen, shorten or repeat a portion of a cycle.
To set or reset the timer, push timer knob in to stop the
washer. Hold timer knob in firmly while slowly turning it
clockwise to the setting desired. Pull timer knob out to
start the washer.
DOOR LOCKED Light
When the washer is started, the "DOOR LOCKED" light
will come on after a short delay. The light will turn off
10 to 30 seconds after the cycle is complete.
HEATER ON Light
This light comes on during the Boosted Hot setting only.
While the washer is heating, the HEATER ON light will
turn on. The light will go off when the washer tumbles
and will come back on when the heater is on.
Out of Balance Load
If at the end of the cycle, the load is dripping wet, the
washer has limited the spin speed. This is to prevent
damage to the unit if there is a severely unbalanced load.
If this condition occurs, redistribute the load manually
and repeat the cycle beginning at the last rinse.
If the condition persists, consider steps discussed in the
Before Washing section of the Use and Care Guide.
800795

End of Cycle Signal

The volume of the signal tone may be set on OFF, LOUD
or between the two selections. If a volume level is
selected, the signal tone will buzz on and off when the
cycle is completed. The signal will stop when the door is
opened, or when the timer has advanced to an OFF
position.
NOTE: If the signal comes on and remains on, the
washer may have sensed an error. Unplug the washer,
shut water off to washer and contact a service person.
W549I
5