Fedders A6V05S2B Manual Del Propietário página 4

INSTALLATION
WINDOW INSTALLATON
9. Cut two pieces of adhesive back foam seal to height
of window opening. Remove backing and apply to
window frame and sliding sash that will rest against
unit (Fig. 5).
10. Slide unit onto support platform. Be sure unit side
channel butts against vertical edge of window frame.
Note: If unit side channel does not fit securely, remove unit and
readjust leveling bolt.
11. Drill two 1/8" holes through window channel frame
in alignment with existing holes in bottom bar.
Install two (2) 3/8" long self-tapping screws through
these holes. If window channel frame is not tall
enough to use existing holes, drill (2) new holes off
to the side of the existing holes to attach the unit
bottom bar to the support platform. Unit should be
firmly anchored to window channel frame or
support platform (Fig. 6).
12. Slide inside window sash closed. Be sure vertical
edge of inside window sash is pressed firmly against
side of unit cabinet. Cut remaining adhesive back
foam seal to width of window opening. Remove
backing and apply to top inside edge of window
frame (Fig. 5).
13. Install speed clips on top and bottom inside edge of
window to provide locking (Fig. 7).
14. Using supplied plastic foam seal, cut to proper
length, insert between inside window sash and
outside window (Fig. 7).
15. Place top retainer on top edge of filler panel,
(Fig. 5) then place the bottom edge of filler panel
into groove of bottom retainer (mounted on unit).
Filler panel may be trimmed with knife or scissors to
fit window height.
16. Slide sliders upward making sure filler panel aligns
in sliders (Fig. 5).
17. With sliders up against top retainer, drill 1/8" hole
through window frame in alignment with existing
hole in slider. Install 3/8" long self-threading screw
in hole. Repeat for other slider (Fig. 6 & 7).
18. Check all seals and plug all air leaks around unit.
Use sealant to fill any minor openings.
All manuals and user guides at all-guides.com
4
Fig. 5
B
A
C
D
A
E
Foam Seal
A
Top Retainer
B
Filler Panel
C
Do not obstruct the air intake area of your air conditioner,
as this could cause overheating, thus activating the units
security switch and shutting off the unit. Do not block
aiflow inside with blinds, curtains, or furniture. Do not
block airflow outside with shrubs, enclosures, or other
buildings.
Fig. 6
A
Widow Channel Frame
A
Drilled Holes
B
Bottom Bar
C
Do not drill a hole in the bottom pan. Unit is
designed to operate with approximately 1/2" of
water in bottom pan.
Sliders
D
Side Channel
E
C
B
D
3/8" long self tapping screws
D