Kohler SYMBIO K-1345 Instrucciones De Instalación
Ocultar thumbs Ver también para SYMBIO K-1345:
Idiomas disponibles

Idiomas disponibles

BEFORE YOU BEGIN
TOOLS AND MATERIALS REQUIRED
S
Carpenter's square
S
Screwdrivers
S
Pencil
PRODUCT REQUIREMENTS
The apron and end panel must be installed before the
finish floor and wall materials are installed, and at the
same time as the bath/whirlpool.
This apron system is designed to have the finish wall
materials (1-1/2" (3.8cm) max.) go over the apron
columns. It is also designed to have the finish floor
materials (2" (5cm) max.) butt up against the apron frame.
INSTALLATION
INSTALL BATH/WHIRLPOOL
Install the bath/whirlpool according to the instructions
included with the product.
INSTALL END PANEL
1.
Lift the bath/whirlpool slightly along the outside end,
and insert the end panel flange into the groove
underneath the bath rim.
2.
Position the end panel so the side flange is behind
the corner post. Align the three fastener holes in the
end panel with the holes in the corner post, and
loosely fasten the bolts and hex nuts.
3.
Use a carpenter's square to square the corner post,
bath, receptor, and end panel with the floor. Secure
the corner post firmly to the floor with two screws.
B
1007225-2-
R
Español, Página 5
Français, Page 9
SYMBIO
BATH/WHIRLPOOL APRON
K-1345, K-1347, K-1350, K-1351
S
Measuring tape
S
Shimming material (as needed)
The apron can be used as access to the whirlpool pump
and controls, when applicable. Additional access,
however, may make servicing of the pump and controls
easier.
Top
Flange
End Panel
Side Flange
Screw
Three Fastener
Holes
Corner Post
Screws
REMOVABLE
AND END PANEL
Groove
Underneath
Whirlpool Rim
Washer
Hex Nut
Lift
Square
E 2001 Kohler Co.
Tabla de contenido
loading

Resumen de contenidos para Kohler SYMBIO K-1345

  • Página 5: Symbio Plataforma Removible De Bañera/Bañera De Hidromasaje

    Asegure el pilar de la esquina Brida lateral al piso con dos tornillos. Tornillo Levante Tres huecos de Escuadra los sujetadores Pilar de la esquina Tornillos Kohler Co., Kohler, WI U.S.A. 1007225-2-...
  • Página 6 Verifique que la estructura de la plataforma esté nivelada con el piso. Igualmente, asegure el pilar de la esquina al piso, y asegure todas las tuercas. Tornillos, arandelas y Escuadra tuercas hexagonales Estructura de la plataforma Kohler Co., Kohler, WI U.S.A. 1007225-2-...
  • Página 7 Panel de la plataforma 10. Instale el material de la pared acabada y el piso acabado. El grosor máximo de la pared es de 1-1/2” (3,8cm). El grosor máximo del piso es de 2” (5cm). Kohler Co., Kohler, WI U.S.A. 1007225-2-...
  • Página 8 ¿Preguntas? ¿Problemas? Primero, revise las instrucciones para asegurarse de haber realizado la instalación correcta. Para mayor asistencia, llame a nuestro Departamento de Atención al Cliente. También puede localizarnos en la dirección de Internet escrita abajo. En los Estados Unidos, llame al 1-800-4-KOHLER En México, llame al 001-877-680-1310 En Canadá, llame al 1-800-964-5590 www.kohler.com...

Este manual también es adecuado para:

Symbio k-1347Symbio k-1350Symbio k-1351

Tabla de contenido