Makita TW007G Manual De Instrucciones página 9

Ocultar thumbs Ver también para TW007G:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Changing the application mode
This tool employs several easy-to-use application modes for driving bolts with good control.
The type of the application mode changes every time you press the button
You can change the application mode within approximately one minute after releasing the switch trigger.
NOTE: You can extend the time to change the application mode approximately one minute if you press the button
Application mode
(Assist type displayed on panel)
Bolt mode
Bolt mode (1)
Bolt mode (2)
Bolt mode (3)
: The lamp is on.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the
application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.
Feature
Clockwise
This mode helps to repeat screwdriving continuously with
equal torque. This mode also helps to reduce the risk of
breakage of bolts/nuts due to overtightening.
Counterclockwise
This mode helps to prevent a bolt from falling off. When loosening a
bolt with the tool driving in counterclockwise rotation, the tool automati-
cally stops or slows down after the bolt/nut gets enough loosened.
NOTE:
The timing to stop the driving varies depending on the
type of the bolt/nut and material to be driven. Make a
test driving before using this mode.
Clockwise
The tool stops automatically as soon as it has started
impact blows.
Counterclockwise
The impact force is 4. The tool stops automatically as soon
as it has stopped impact blows.
Clockwise
The tool stops automatically approximately 0.5 second later
from the moment that the tool has started impact blows.
Counterclockwise
The impact force is 4. The tool stops automatically approximately 0.2
second later from the moment that the tool has stopped impact blows.
Clockwise
The tool stops automatically approximately 1 second later
from the moment that the tool has started impact blows.
Counterclockwise
The tool slows down the rotation after it has stopped impact blows.
9 ENGLISH
.
Purpose
Clockwise
Preventing overtightening of
bolts.
Counterclockwise
Loosening bolts.
or
.
.
Tabla de contenido
loading

Este manual también es adecuado para:

Tw008g

Tabla de contenido