Technical Support; Reglage De La Temperature - IARP BRERA Instrucciones De Uso

Modello - Model - Modèle
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
INSTRUCTIONS FOR TECHNICAL SUPPORT
TECHNICAL SUPPORT: Specialist staff and staff responsible for installation and technical support
operations on the vending machine.
The following instructions are strictly the responsibility of technical support.
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention
on the flammable refrigerants.
ATTENTION! Use protective shoes and gloves during maintenance operations.
15. PLACEMENT AND LEVELING OF THE MACHINE
The equipment has 4 adjustable feet.
The leveling can be obtained using a 33 mm wrench.
It is strictly necessary after positioning to stabilise the equipment on the ground.
16. INSTALLATION OF PAYMENT SYSTEM
The vending machine is pre-set for the installation of a number of payment system:
• Banknote reader;
• Credit Card reader;
• Key reader;
• Coin acceptor/change return reader;
• Coin validator.
The payment system must comply with the safety specifications of the international standards applicable
to the product.
The distributor is supplied without any payment system, it will be the responsibility of the installer to provide for its
assembly.
After installing your required payment system, the programming menu must be adjusted, by setting the parameters
corresponding to your selected payment system (see Programming manual).
The Manufacturer shall not be held responsible for any damages to the vending machine, persons and/or
property resulting from wrong installation of the payment system.

17. REGLAGE DE LA TEMPERATURE

The vending machine is equipped with an electronic system to automatically maintain the temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can proceed as follows:
1. Open the column.
2. Press the BLUE key of the MASTER BOARD.
3. On the front touch display press the item
"Master".
4. Press the item "Parameters".
5. Press the item "Cooling system".
6. Press the item "Set Point".
7. Press  or  to increase or decrease the set
point value.
BRERA
CHELSEA
TROCADERO
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1
2 8 / 9 6
PAGE
UM000492
N° DOC
2