Makita HR3200C Manual De Instrucciones página 5

NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Speed change
► 1. Adjusting dial
The revolutions and blows per minute can be adjusted
just by turning the adjusting dial. The dial is marked 1
(lowest speed) to 5 (full speed).
Refer to the table below for the relationship between the number settings on the adjusting dial and the revolu-
tions/blows per minute.
Number on Revolutions per
adjusting dial minute
5
4
3
2
1
CAUTION:
• If the tool is operated continuously at low
speeds for a long time, the motor will get over-
loaded, resulting in tool malfunction.
• The speed adjusting dial can be turned only as
far as 5 and back to 1. Do not force it past 5 or
1, or the speed adjusting function may no longer
work.
1
Blows per minute
630 3,300
590 3,100
480 2,500
370 1,900
315 1,650
Changing the quick change chuck
for SDS-plus
For Model HR3210FCT
The quick change chuck for SDS-plus can be easily
exchanged for the quick change drill chuck.
Removing the quick change chuck
for SDS-plus
1
2
3
► 1. Quick change chuck for SDS-plus 2. Change
cover 3. Chuck cover
CAUTION:
• Before removing the quick change chuck for
SDS-plus always remove the bit.
Hold the change cover with the thumb and the mid-
dle finger and pull it in the direction arrow 1. With the
change cover pulled in that direction, hold the chuck
cover with the index finger. While holding the chuck
cover so, pull out the quick change chuck for SDS-plus
in the direction of arrow 2 at a stroke.
Attaching the quick change drill
chuck
1
3
2
► 1. Spindle 2. Quick change drill chuck 3. Change
cover
Grasp the change cover and place the quick change drill chuck on the spindle of the tool.
Make sure that the quick change drill chuck is secured
by trying to pull it several times.
5 ENGLISH
2
1