Genius AMICODE 868 Manual De Instrucciones página 8

Steps for changing over the keypad to SLAVE:
3 beeps
Keys 7+9
Keys 1+3
3.6. Learning the system code through the Amigo radio control
You can transfer the system code to the keypad from an already stored Amigo radio control. For this operation, the radio control
must be set to MASTER.
Steps for transmitting the system code of the radio control to the keypad:
1 - Set the radio control in teaching mode (see the relevant instructions).
2 - Press and hold down the key of the radio control with the code to be transferred.
3 - Type the PIN Code on the keypad.
4 - Press and hold down the push-button relating to the channel on which you wish to copy the system code, bringing the two
devices into contact.
5 - If the system code was correctly saved, the keypad will sound a long beep to confirm in-memory storage.
Keypad installation steps:
1 - Rest the keypad in the position where you wish to install it, move it down by 5 to 10 mm and mark the hole for the top fixing screw
at the centre of the keypad.
2 - Drill, and tighten the screw, leaving 3-4mm space under the screw head.
3 - Position the keypad on the top screw and mark the lower securing point (fig. 2).
4 - Drill the hole and secure the keypad.
5 - Re-position the battery (fig. 3, ref. A), observing the polarity indicated on the bottom of the keypad (fig. 3).
6 - Close the cover (fig. 3, ref. B) by screwing the two supplied screws (fig. 3, ref. C).
Manufacturer: GENIUS s.r.l.
Address: Via Padre Elzi, 32 - 24050 - Grassobbio - BERGAMO - ITALY
Declares that: the device AMICODE 868
• complies with the essential safety requirements of the following Directives:
73/23 EEC and subsequent amendment 93/68 EEC.
89/336 EEC and subsequent amendments 92/31 EEC and 93/68 EEC.
Notes:
these products have been subject to testing procedures carried out under standardised conditions (all products manufactured
by GENIUS s.r.l.).
Grassobbio, 01-05-2005
3 beeps 1 long beep
Input the
programming
password
4. INSTALLATION
Do not open the keypad for any reason.
Install the keypad only after doing the programming.
Fig. 2
5. EC COMPLIANCE DECLARATION
changeover done
IMPORTANT:
Managing Director
6
Exit from
programming
(keypad OFF)
D. Gianantoni
Fig. 3