Parts List - LUND LN23576784 Instrucciones De Instalación

PARTS LIST:

1 Driver/left side 4" Oval Straight Nerf Bar
1 Passenger/right side 4" Oval Straight Nerf Bar
6 Mounting Brackets
Front
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
1. Start the installation under the passenger side of the vehicle. Locate the front (3) factory studs
along the inner side of the body panel, (Figure 1). Use a wire brush or thread chaser die to
remove excess paint or undercoating from threaded studs as necessary.
2. Select (1) Mounting Bracket. NOTE: All (6) brackets are universal and will fit left or right side.
Attach the mounting bracket to the (3) factory studs with (3) 8mm Flat Washers and (3) 8mm
Nylon Lock Nuts, (Figures 2 & 3). Leave brackets loose at this time.
3. Repeat Steps 1 & 2 to install the mounting brackets in the center and rear mounting locations
along the body panel, (Figures 4—6).
4. Carefully unwrap and select the Passenger/right nerf bar. Use the illustration above to help
identify the correct nerf bar. Place it on top of the brackets. IMPORTANT: Do not slide, (front to
back or rotate), the nerf bar on the brackets or damage to the finish on the nerf bar may result.
5. Attach the nerf bar to the brackets with (6) 8mm Combo Hex Bolts, (Figures 7—10). Do not
tighten hardware at this time.
6. Level and adjust the nerf bar as necessary and fully tighten all hardware.
7. Repeat Steps 1—6 for Driver/left nerf bar installation.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to add a
protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish. Mild soap may be used also to clean the Sidebar.
12
18
18
(6) Left or Right
Mounting Brackets
Passenger/right
Nerf Bar
Page 1 of 3
4" OVAL STRAIGHT NERF BARS
2019 RAM 1500 QUAD CAB
8-1.25mm x 25mm Combo Hex Bolts
8mm x 24mm x 2mm Flat Washers
8-1.25mm Nylon Lock Nuts
Arrows indicate location of
threaded inserts in bottom
of Nerf Bar