Makita HR2432 Manual De Instrucciones página 6

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Side grip (auxiliary handle)
3
2 1
005874
CAUTION:
Always use the side grip to ensure operating safety.
•
Install the side grip so that the teeth on the grip fit in
between the protrusions on the tool barrel. Then tighten
the grip by turning clockwise at the desired position. It
may be swung 360° so as to be secured at any position.
Bit grease (optional accessory)
Coat the bit shank head beforehand with a small amount
of bit grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and longer
service life.
Installing or removing the bit
1
2
001296
Clean the bit shank and apply bit grease before installing
the bit.
Insert the bit into the tool. Turn the bit and push it in until it
engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
1. Tighten
2. Loosen
3. Side grip
(auxiliary
handle)
1. Bit shank
2. Bit grease
6
005875
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
005876
Bit angle (when chipping, scaling or
demolishing)
2
1
005877
The bit can be secured at the desired angle. To change
the bit angle, depress the lock button and rotate the
action mode changing knob to the O symbol. Turn the bit
to the desired angle.
Depress the lock button and rotate the action mode
changing knob to the
bit is securely held in place by turning it slightly.
005878
1. Bit
2. Chuck cover
1
2
1. Bit
1
2. Chuck cover
2
1. Action mode
changing knob
2. Lock button
symbol. Then make sure that the