Remove The 17W Led Assembly; Installing The Light Kit Plate - Kichler ARVADA Manual Del Usuario

REMOVE THE 17W LED ASSEMBLY FROM LIGHT KIT PLATE
Step 1. Remove the screw from circular hole and loosen the other two screws from
key holes approximately 1/4 turn. Keep the screw that removed aside for use later.
Step 2. Turn the key holes from the 17W LED assembly from the two screws
loosened previously and remove the 17W LED assembly from the light kit plate.

INSTALLING THE LIGHT KIT PLATE

Step 1. Remove one of the three screws from the fan motor assembly mounting
ring and loosen, but not remove, the other two screws.
Step 2. Place the key holes from the light kit plate over the two screws previously
loosened from the fan motor assembly mounting ring. Turn the light kit plate
until it locks in place at the narrow section of the key holes. Secure by tightening
the two screws previously loosened and the one screw previously removed.
Circular
hole
Screw
Fig. 28
Fig. 29
Light kit
plate
17w led
assembly
Key hole
Mounting ring
Light kit
plate
Key hole
Screw