Programming - Vimar ELVOX SW230.T Manual De Instrucciones Para La Conexión Y El Uso

SW230.T / SW230.T.120

10. Programming.

Before you begin programming, we recommend you save at least one remote control associated with input SEQ.
Manual tuning procedure to position the gate.
In order to perform the gate positioning manoeuvres before you begin any learning or checks, there is a function designed to move one motor at a time,
both opening and closing, in dead-man mode.
To enter this mode, press both push buttons P1 and P2 simultaneously, then LED DL7 lights up permanently to indicate dead-man tuning mode.
Release the buttons.
Now both push buttons control P1 motor 1 and P2 motor 2, respectively, in cyclic mode.
Simply hold down one of the two push buttons to move the respective motor, which each time the button is pressed again will invert the direction of
motion, thereby having complete control of both directions.
10.1. SIMPLIFIED DOUBLE LEAF learning procedure WITH deceleration.
1. Begin the procedure with the gate closed.
2. Press push button P1 and hold it down until LED DL7 starts to flash (1
3. Release push button P1.
4. Follow the programming phases shown in the figure.
5. Programming ends when LED DL7 stops flashing.
CAUTION: After resetting or powering the board, the travel time of the first closing manoeuvre increases by approximately 5 seconds to allow the
completion of motion in any case.
1 START
st
DECEL.ZONE OP. M1
2 START
nd
3 START
rd
DECEL.ZONE OP. M2
4 START
th
5 START
th
30
flashing frequency).
st
The first START begins the
learning process by moving
MOTOR 1 in opening
(Caution! start with the
gate closed)
The second START
sets the starting point
of MOTOR 1 opening
deceleration
The third START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
The fourth START sets the
starting point of MOTOR 2
opening deceleration
The fifth START sets the
MOTOR 2 travel end and
should be pressed when
leaf 2 reaches the stop
EN
6 START
th
DECEL.ZONE CL. M2
7 START
th
DECEL.ZONE CL. M1
8 START
th
9 START
th
The sixth START sets the
starting point of MOTOR 2
closing deceleration
The seventh START sets
the MOTOR 2 travel end
and should be pressed
when leaf 2 reaches the
stop
The eighth START sets the
starting point of MOTOR 1
closing deceleration
The ninth START sets the
MOTOR 1 travel end and
should be pressed when
leaf 1 reaches the stop
To complete programming,
wait for the gate to be
completely closed and LED
DL7 to be off